Coil on Core

coilcore-01When Fuller Custom Brush originated the Fullergript® design, a revolutionary brush making process was created.The Fullergript® process provides an economical means of incorporating brush technology into a wide range of modern commercial applications.

By winding Brush Strip on a mandrel or shaft, a coil brush is produced. Brush density can be varied by your choice of backing size.
The amount of fill material increases proportionately with the size of the backing.
The lead of the coil (distance between wraps), affects the working surface of the brush and its performances.
Consistent or continuous brush to work surface contact requires a close wound coil (no lead), while an open lead is recommended when working with aggregate, grain or debris.


Click for more information on Coil Brush


Step 2: Complete request for quote design form below





Open - dimension from center
of one coil to the center of the
next successive coil.


Fill Material

Backing Material

Core Dimensions


inches inches inches

Core Material

End Plates
inches inches inches

Brush Positioning on Core

Operating RPM

Bristle Penetration intormation


Brush Application or Additional Comments

Upload Drawing

    Select File:

Customer Information

*Please fill out all areas of the form below before submitting.

Leave a Reply

Your email address will not be published. Required fields are marked *