Coil on Core & Shaft

When Fuller Custom Brush originated the Fullergript® design, a revolutionary brush making process was created. The Fullergript® process provides an economical means of incorporating brush technology into a wide range of modern commercial applications. By winding Brush Strip on a mandrel or shaft, a coil brush is produced. Brush density can be varied by your choice of backing size. The amount of fill material increases proportionately with the size of the backing. The lead of the coil (distance between wraps), affects the working surface of the brush and its performances. Consistent or continuous brush to work surface contact requires a close wound coil (no lead), while an open lead is recommended when working with aggregate, grain or debris.

If you have questions or would prefer to order via phone, give us a call at 1-800-227-2961


Fill Material

Backing Material

Core Dimensions

Brush Positioning on Core

Shaft Material

Full Shaft Dimensions

Stub Shaft Dimensions

Brush Usage Requirements


Additional Comments

Upload Drawing

Click or drag a file to this area to upload.

Contact Information

Please fill out the fields below before submitting the form.
Coil on Core Diagram
Coil Shaft Diagram
Coil Shaft Diagram
Fuller Custom Products